In Glass Model-Single and Double Pane


Single In Glass Hale pet door mechanical drawingFlaps: Double flaps (one flap on each frame) made of flexible 3/16” clear PVC vinyl for easy access.  Single flap only on Single In Glass Model. 
Inner Frame:  Inner frame made of two separate metal extrusions.  Three sides entrap the security cover.  Both metals are .063” wall thickness.
Outer Frame: Extruded 6063-T5 aluminum with .063” wall thickness.  Designed to sleeve into the inside frame.
Pet Door Frame:  Single pane model has 1/16” wall designed to accept 3/16” tempered glass and the cover.  Double pane model is used for any glass thicker than 3/16”.
Alnico5 Magnets: A ¼” rod magnet 1 ½” long made from an aluminum, nickel and cobalt alloy known for strength & durability. Door size determines number of magnets.
Strikes:  Made of ferrous stainless steel.  1 ½” long, ¾” tall and 1/32” thick.  U shaped with interior prongs, when squeezed onto the vinyl flap, the barbed prongs hold firmly.
Double Pane In Glass Hale Pet Door mechanical drawingWeather stripping:  Flap is surrounded by ½” black nylon pile for maximum insulation. Nylon is woven into a backing 9/32” wide and 1/32” thick.
Security Cover:  1/4" thick King Starboard® polymer sheet.  Extremely shock and impact resistant.  Has a 3/8” diameter locking hole
Cover Handle: A lightweight zinc alloy cabinet knob pull type handle in a satin nickel finish that is 25/32” wide, 19/32” tall and 53/64” deep with a 1/2” deep and 21/32” wide finger hole. It is attached to the cover with a 12 mm long zinc coated steel flat head Philips screw with a .70 thread size that is countersunk to prevent scratching the frame.
Pin Lock: A ¼” diameter positive action steel pin encased with 5/32” thick fabricated plated steel. 
Build Out:  An extruded aluminum spacer that allows the frames in a double pane installation to be spread apart sufficiently to allow the two frames to be fastened together at the sleeved flange area.
Compensation Strips:  A material such as Plexiglass or Lexan® inserted into two edges of the door frame along one side and the bottom of the pet door to compensate for the missing glass that has been cut away.  Width varies on double pane model and is 3/16” thick on single pane model.
Glass:  Single pane model comes with 3/16” thick tempered replacement glass and double pane model comes with insulated tempered replacement glass up to 2” thick.  The new glass is cut to the size of the original pane of glass and the pet door opening is cut into the bottom left or right hand side.   This new pane of glass is installed into customer’s original frame along with the pet door.  The original pane of glass is removed and saved.